Welcome to MyCiscoLab.com........Your Open Source for Cisco........Obtain Curriculums for your CCNA, CCDA and CCNP........Detailed Information on Configuring and Troubleshooting Cisco Routers and Switches.......Complete Labs to Enable You To Build and Troubleshoot Cisco Internetworks.........




Static Routing Network Lab

The GNS3 application and IOS C2691-EN.BIN are required to complete the following exercise.  If you are using a different IOS then the .NET file will need to be edited.

The purpose of this lab is to configure, verify, and troubleshoot the routers for Static Routing and verify convergence.  Please view the below diagram to see the cabling and IP Addressing and VLSM scheme .  There are 3 lab types listed below:

Blank Lab (Topology Only) - Provides non-configured lab to gain knowledge of provisioning

Preconfigured Lab - Provides fully configured lab to allow for analysis of show / debug commands.

Troubleshooting Lab - Provides incorrectly configured lab to allow for troubleshooting.

  Good Luck!!

(Click on the diagram to access a full size picture for easier viewing)



Download and extract the file into the root directory of your GNS3 folder

(C:\Program Files\GNS3)


Static Routing Lab Files

ALL Static Routing Labs


Static Routing Command and Output Files

Static Routing Management_1 Router

Static Routing Sales_1 Router

Static Routing Sales_2 Router

Static Routing Support_1 Router

Static Routing Support_2 Router

Static Routing Support_3 Router