• Discussion Forums>
    Welcome to MyCiscoLab.com........Your Open Source for Cisco........Obtain Curriculums for your CCNA, CCDA and CCNP........Detailed Information on Configuring and Troubleshooting Cisco Routers and Switches.......Complete Labs to Enable You To Build and Troubleshoot Cisco Internetworks.........

     

     

     

    Single Area Point-to-Point

    OSPF Network Lab

    The purpose of this lab is to complete the configuration of all routers for Single Area Point-to-Point OSPF and verify convergence.  Please view the below diagram to see the cabling and IP Addressing VLSM scheme (Click on the diagram to access a 1200X1200 size picture for easier viewing).  The configuration needed and output configuration files are listed below the diagram.  If you are using the CCNP RouterSim, please attempt to configure a network similar to the one listed below and verify convergence.  Good Luck!!

     

     

    OSPF Configuration Commands

    1601 Commands

    2509 Commands

    2523 Commands

    2610 Commands

    2620 Commands

     

     OSPF Configuration Files

    1601Configuration

    2509Configuration

    2523 Configuration

    2610 Configuration

    2620 Configuration