Welcome to MyCiscoLab.com........Your Open Source for Cisco........Obtain Curriculums for your CCNA, CCDA and CCNP........Detailed Information on Configuring and Troubleshooting Cisco Routers and Switches.......Complete Labs to Enable You To Build and Troubleshoot Cisco Internetworks.........

 

 

 

Inter-VLAN Routing Network Lab

The GNS3 application and IOS C2691-EN.BIN(Router) and C3725-AD.BIN (Switches) are required to complete the following exercise.  If you are using a different IOS then the .NET file will need to be edited.  You will also need to use the Virtual PC application included in each of the Lab files to verify the PC Reachability.

The purpose of this lab is to configure, verify, and troubleshoot the routers and switches for  Inter-VLAN Routing and verify convergence.  Please view the below diagram to see the cabling and IP Addressing and VLSM scheme .  There are 3 lab types listed below:

Blank Lab (Topology Only) - Provides non-configured lab to gain knowledge of provisioning

Preconfigured Lab - Provides fully configured lab to allow for analysis of show / debug commands.

Troubleshooting Lab - Provides incorrectly configured lab to allow for troubleshooting.

Inter-VLAN Configuration Commands & Output

Router Commands

Sales Switch Commands

Mgmt Switch Commands

Support Switch Commands

 

Inter-VLAN Configuration Files

Router Configuration

Sales Switch Configuration

Mgmt Switch Configuration

Support Switch Configuration

 

GNS3 Labs

Inter-VLAN Routing GNS3 Blank Lab (Topology Only)

Inter-VLAN Routing GNS3 Preconfigured Lab

Inter-VLAN Routing GNS3 Troubleshooting Lab