Welcome to MyCiscoLab.com........Your Open Source for Cisco........Obtain Curriculums for your CCNA, CCDA and CCNP........Detailed Information on Configuring and Troubleshooting Cisco Routers and Switches.......Complete Labs to Enable You To Build and Troubleshoot Cisco Internetworks.........

 

 

 

Frame Relay Network Lab

The GNS3 application and IOS C2691-EN.BIN are required to complete the following exercise.  If you are using a different IOS then the .NET file will need to be edited.

The purpose of this lab is to configure, verify, and troubleshoot the routers for  Frame Relay and verify convergence.  Please view the below diagram to see the cabling and IP Addressing and VLSM scheme .  There are 3 lab types listed below:

Blank Lab (Topology Only) - Provides non-configured lab to gain knowledge of provisioning

Preconfigured Lab - Provides fully configured lab to allow for analysis of show / debug commands.

Troubleshooting Lab - Provides incorrectly configured lab to allow for troubleshooting.

Frame Relay Configuration Commands & Output

Mgmt Commands

Sales1 Commands

Sales2 Commands

Sales3 Commands

 

Frame Relay Configuration Files

Mgmt Configuration

Sales1 Configuration

Sales2 Configuration

Sales3 Configuration

 

GNS3 Labs

Frame Relay GNS3 Blank Lab (Topology Only)

Frame Relay GNS3 Preconfigured Lab

Frame Relay GNS3 Troubleshooting Lab