Welcome to MyCiscoLab.com........Your Open Source for Cisco........Obtain Curriculums for your CCNA, CCDA and CCNP........Detailed Information on Configuring and Troubleshooting Cisco Routers and Switches.......Complete Labs to Enable You To Build and Troubleshoot Cisco Internetworks.........

 

 

 

EIGRP Network Lab

The GNS3 application and IOS C2691-EN.BIN are required to complete the following exercise.  If you are using a different IOS then the .NET file will need to be edited.

The purpose of this lab is to configure, verify, and troubleshoot the routers for  EIGRP and verify convergence.  Please view the below diagram to see the cabling and IP Addressing and VLSM scheme .  There are 3 lab types listed below:

Blank Lab (Topology Only) - Provides non-configured lab to gain knowledge of provisioning

Preconfigured Lab - Provides fully configured lab to allow for analysis of show / debug commands.

Troubleshooting Lab - Provides incorrectly configured lab to allow for troubleshooting.

EIGRP Configuration Commands & Output

Sales1 Commands

Sales2 Commands

Mgmt1 Commands

Support1 Commands

Support2 Commands

Support3 Commands

 

EIGRP Configuration Files

Sales1 Configuration

Sales2 Configuration

Mgmt1 Configuration

Support1 Configuration

Support2 Configuration

Support3 Configuration

 

GNS3 Labs

EIGRP GNS3 Blank Lab (Topology Only)

EIGRP GNS3 Preconfigured Lab

EIGRP GNS3 Troubleshooting Lab

 

Command Output and Descriptions

Command List